PLANET WNAP-6306 - Manual (Page 45)

User’s Manual of WNAP-6306
You may set up a safe network via the following methods:
I. By Push Button Configuration (PBC)
If the wireless adapter supports Wi-Fi Protected Setup and the Push Button Configuration (PBC)
method, you can add it to the network by PBC with the following two methods.
Step 1: Choose WPS PBC Settings, and click “Connect”.
Figure 5-21 WPS PBC Settings
Step 2: Press and hold the WPS Button equipped on the adapter directly for 2 or 3 seconds. Or you
can click the WPS button with the same function in the configuration utility of the adapter.
1) Step 1 & 2 should process within two minutes.
2) WNAP-6306 only supported Software PBC.
Step 3: Wait for a while until the connection established to complete the WPS configuration.
II. By PIN
If the new device supports Wi-Fi Protected Setup and the PIN method, you can add it to the network by
PIN with the following two methods.
Method One: Enter the PIN of your Wireless adapter into the configuration utility of the AP
Step 1: Choose WPS PIN Settings, and enter the PIN code of the wireless adapter.
Figure 5-22 PIN of Wireless Adapter
- 45 -