PLANET WAP-4000 - Manual (Page 9)

- 4 -
Chapter 2 Hardware Installation
Before you proceed with the installation, it is necessary that you have enough information about the
WAP-4000.
1. Locate an optimum location for the WAP-4000. The best place for your WAP-4000 is usually
at the center of your wireless network, with line of sight to all of your mobile stations.
2. Assemble the antennas to WAP-4000. Try to place them to a position that can best cover your
wireless network. The antenna ’s position will enhance the receiving sensitivity.
3. Connect RJ-45 cable to WAP-4000. Connect this WAP-4000 to your LAN switch/hub or a single
PC.
4. Plug in power adapter and connect to power source. After power on, WAP-4000 will start to
operate.
Note: ONLY use the power adapter supplied with the WAP-4000. Otherwise, the product may be
damaged.
If you want to reset your WAP-4000 to default settings, press the Reset button 5 second. And
then wait for 10 seconds for WAP-4000 to reboot.