PLANET WAP-4000 - Manual (Page 22)

- 17 -
3.1.8 Tools:
You can backup or restore WAP-4000 settings, reset WAP-4000 to factory default and upgrade
firmware in this option.
Backup Settings: You can backup current settings to a file. Press “Backup” button, it will prompt
you a location to save the backup file (config.bin).
Restore Settings: When you try to restore the settings you have saved, please press “Browse…” to
find out the backup file and then press “Restore”.
Restore to default settings: It is used to reset WAP-4000 ’s configuration to factory default.
Firmware Upgrade: You can upload the newest firmware of the WAP-4000. You may either enter
the file name in the entry field or browse the file by clicking the Browse button.
3.2 Configure through PLANET WAP-4000 Utility
The PLANET WAP-4000 Utility is provided to configure the WAP-4000. It can be used to configure
multiple WAP-4000s at the same time in an easiest way.
3.2.1 Installation
1. Insert the User ’s Manual and Utility CD into the CD-ROM drive.
2. Run setup.exe under E:\Utility\WAP-4000\ directory, or click the Start button and choose Run.
When the dialog box appears, enter E:\Utility\WAP-4000\setup.exe (Assume
“E” is your
CD-ROM drive). You will see the dialog box as below. Please click Next to continue.