PLANET MAP-3020 - Manual (Page 8)

For the safety reasons, you are recommended never to touch a high-gain
antenna when it is transmitting or point it at any part of your body.
Please, follow carefully the instructions with your antenna.
Keep antennas away from metal objects/obstructions (heating and air-condi-
tioning ducts, large ceiling trusses, building superstructures, and major power
cabling runs).
Use a directional antenna when you establish a link between two buildings.
A directional antenna must be properly aligned to the point at the other
antenna, line-of-sight.
Locate an omni-directional antenna in the middle of the desired coverage area
if possible.
Place the antenna as high as possible to increase the coverage area.
Outdoor antennas should be mounted at a sufficient height to prevent the
radio path from above the obstructions such as trees and buildings.
Antenna towers should keep a safe distance from overhead power lines. The
recommended safe distance is twice the tower height.
3. Using Category 3 or higher UTP or STP cable, connect the LAN port of Mesh
AP to a 10Mbps or 10/100Mbps Ethernet switch, and connect the management
station to switch on the same LAN.
4. Connect the power adapter to the receptor on Mesh AP and plug the other end
to a wall outlet or power strip.
Note
1. ONLY use the power adapter supplied with the Mesh AP. Other-
wise, the product may be damaged.
2. The LAN Port, LAN Port#1 or Public Port of Mesh AP supports
802.3af POE. The pins for supplying the electricity are 1, 2, 3, 6.
If the Mesh AP is powered from POE, you can skip step 4 above.
3. Connect 802.3af PoE to both LAN and Public of your Mesh AP
will damage your device permanently.
l
l
l
l
l
l
l
l