PLANET VC-201A User Manual
Page 21

21
to the telephone line system, on the other hand, need to install
a Slave (VC-201A / VC-204 CPE) converter on the individual
client side and connect to the Multi-port Master through the
telephone lines.
When deciding where to put the converter then you must
ensure:
It is accessible and cables can be connected easily.
Cabling is away from sources of electrical noise such as
radios, transmitters and power lines and fluorescent lighting
fixtures.
Water or moisture can not enter the Converter.
Air flow around the unit and through the vents in the side
of the case is not restricted (company recommend that you
provide a minimum of 25mm inch clearance)
To prolong the operational life of your units:
Do not place objects on top of any unit or stack
3.2 Connecting VC-201A / VC-204
3.2.1 Connecting Standalone PC
Refer to the following procedures to setup the VC-201A to a
standalone PC.
1. Set the VC-201A to be CO mode or CPE mode from the DIP
switch at the rear panel.
2. Power on the VC-201A by connecting its power source.
3. Power LED will illuminate.
4. Connect VDSL line from another VDSL device to VDSL port of
the VC-201A.
5. LNK LED will from blinking to illuminate.
l
l
l
l
l