PLANET GT-1205A - Manual (Page 11)

11
3.3 Chassis Installation And Rack Mounting
To install the media converter in a 10-inch or 19-inch with
standard rack, follow the steps described below.
Step 1: Find an available slot
from your PLANET MC
Chassis.
Step 2: Follow Figure 3-2,
carefully slide in the
converter fully and
firmly fitted to the
slot of the chassis.
The Power LED of the
converter will turns ON.
Figure 3-2: Insert GT-1205A
Media Converter into an
available slot
Note
1. Never push the converter into the slot with
violent, it could damage the chassis.
2. The Media Converter Chassis supports hot-
swap, there is no need to turn off the whole
chassis before slide in the new converter.
3.4 Din-Rail Installation
The GT-1205A also supports din-rail installation, the option kit
RKE-DIN can help to mount the converter to the Rail system,
please follow the steps below.
Step 1: Use the bundled screw to fix the RKE-DIN to the
converter.
Step 2: Hook the converter to the DIN-Rail.
Note
You must use the screws supplied with the
RKE-DIN. Damage caused to the parts by using
incorrect screws would invalidate your warranty.