PLANET GT-1205A User Manual
Page 10

10
1000Base-X
LC Fiber
1000Base-X
LC Fiber
1000Base-X
SFP Transceiver
5V DC power
10/100/1000Base-T
UTP
Figure 3-1: GT-1205A Media Converter Stand Alone Installation
Step 4: Connect the fiber cable. Attach the duplex LC
connector on the network cable into the SFP
transceiver.
Step 5: Attach fiber cable from the GT-1205A to the fiber
network. TX, RX must be paired at both ends.
Step 6: Connect the 5V DC power adapter to the GT-1205A
and verify that the Power LED lights up.
Step 7: Turn on the power of the device/station; the LINK
LED should light when all cables are well attached.
Note
1. It is recommends using PLANET MGB series SFP
modules for the converter. If you insert a SFP
trans-ceiver that is not supported, the converter
will not recognize it. Please check appendix or
go visit our WEB site for details specification
information. http://www.planet.com.tw
2. To prevent from optic acceptor malfunction,
check the both wires / transmitter before power
on the con-verter.
3. To remove the SFP module, please remove the
fiber connectors in advanced and push the belt
or letch of the module. Pull out the module
with violent may damage the module and the
converter.