PLANET POE-150 - Manual (Page 13)

8 9
LED of POE-150S / POE-150 will start to flash continu-
ously.
Figure 5: Connection to POE-150S

NOTE:
Supporting IEE802.3af, POE-150 will not
inject power to the cable if you are not con-
necting to an 802.3af device.
Warning:
POE-150S only accepts IEEE802.3af power
supply equipment, any other in-line power
device not comply to 802.3af sending power
through UTP wire to POE-150S may cause
the POE-150S malfunction.
2. Connect the UTP cable in the package from “Ethernet” of
POE-150S to the RJ-45 port of remote device.
3. Connect proper DC plug from “DC OUT” of POE-150S to
remote device.
Caution:
Please ensure the output voltage is correct
before applying power to remote device.
4. Power on the remote device and the LED indicator on
POE-150S will remain on.