PLANET IPOE-162 - Manual (Page 16)

16
6. Hardware Installation
This Industrial IEEE 802.3at Gigabit High Power over Ethernet Injector
provides three different running speeds – 10Mbps, 100Mbps and
1000Mbps in the same device and automatically distinguishes the
speed of incoming connection. Please refer to following sections for
detail information about Industrial IEEE 802.3at Gigabit High Power
over Ethernet Injector.
Before Installation
Before your installation, it is recommended to check your network
environment. If there has any IEEE 802.3at devices need to power on,
the IPOE-162 can provide you a way to supply power for this Ethernet
device conveniently and easily.
If there is very difficult to find a power socket for AC-DC Adapter to
your Non-IEEE 802.3at networked device, the IPOE-162 with POE-162S
/ IPOE-162S can provide you a way to supply DC power for this
Ethernet device conveniently and easily.
Note
The IPOE-162 with IPOE-162S / POE-162S is installed
in pair. However, the use of third-party device is allowed
if the device complied with IEEE 802.3at Power over
Ethernet.
IPOE-162 Injector Installation
1. Connect the Power (Range from AC 24V or DC 24 ~ 48V) to 6-pin
terminal block of IPOE-162. The power LED will be steady on.
2. Connect a standard network cable from Switch / workstation to
“Ethernet” port of IPOE-162.
3. Connect the long cable that will be used to connect to the remote
device to the port “Ethernet + DC”.
4. Due to the capability of IEEE 802.3at Power over Ethernet, the IPOE-
162 can directly connect with any IEEE 802.3at / IEEE 802.3af end-
nodes such as PTZ (Pan, Tilt & Zoom) network cameras, PTZ Speed
Dome, color touch- screen Voice over IP (VoIP) telephones, multi-
channel wireless LAN access points.