PLANET IPOE-162 - Manual (Page 15)

15
Step 2: Lightly press the button of DIN-Rail for remove it from the
track.
5.3 Wall Mount Plate Mounting
To install the Industrial Equipment on the wall, please follows the
instructions described below.
Step 1: Remove the DIN-Rail from the Industrial Equipment; loose
the screws to remove the DIN-Rail.
Step 2: Place the wall mount plate on the rear panel of the Industrial
Equipment.
Figure 9: Attach Brackets to the Industrial Equipment.
Step 3: Use the screws to screw the wall mount plate on the
Industrial Equipment.
Step 4: Use the hook holes at the corners of the wall mount plate to
hang the Industrial Equipment on the wall.
Step 5: To remove the wall mount plate, reverse steps above.