PLANET IPOE-162 - Manual (Page 11)

11
1. Insert Positive / Negative DC power wires or Neutral / Line AC power
wires into the contacts 1 and 2 for POWER 1, or 5 and 6 for POWER
2.
1 2 3 4 5 6
Figure 2: Power input PINs.
2. Tighten the wire-clamp screws for preventing the wires from loosing.
1 2 3 4 5 6
Power 1 Fault Power 2
- + - +
Figure 3: PWR1 & PWR2 Pin of Terminal Block.
Note
The wire gauge for the terminal block should be in the
range between 12 ~ 24 AWG.