PLANET ICA-4200V - Manual (Page 16)

Full HD 20M IR Vari-Focal Dome IP Camera
ICA-4200V
7 12V DC out 12V DC output, 50mA (maximum)
8 DI Digital signal input
9 GND Ground
10 DO Digital signal output
11 N/A
12 N/A
RJ45
(LAN Socket, PoE )
Connecting to PC or Hub/Switch
For connection to 10BASE-T Ethernet or 100BASE-TX Fast Ethernet
cabling, this Ethernet port built auto-negotiation protocol can detect
or negotiate the transmission speed of the network automatically.
Please use CAT-5 cable to connect the Network Camera to a
100Mbps Fast Ethernet network switch or hub.
ONLY use one power source, either from DC or from
802.3af Power over Ethernet.
12V DC in & Power
ND G
The input power is DC 12V, 1A.
ONLY use the power adapter supplied in the package.
Otherwise, the product may be damaged.
Mic in
(audio in)
Connect an external microphone to the camera.
Audio out +/-
Connect a loud speaker to the camera. This function is for voice alert
and two-way audio.
Video out
Connect a TV monitor to the camera. User can check the focus/zoom
and view angle of the camera.
Factory Default
eset R
This button is used to restore all the factory default settings.
Restore the device:
a. Press the button down continuously.
b. Hold the button for at least 5 seconds and release it. The device
has been restored to default settings and reboot again.
Micro SD Card Slot User can insert a micro SD card into this slot for recording.
2.2 Hardware Installation
1. Please select the most suitable position on ceiling to install the camera.
2. Remove two screws to release the top cover of the dome and open it.
16