PLANET ICA-3350P - Manual (Page 45)

3 Mega-pixel Remote Focus Bullet IR IP Camera
ICA-3350P
45
3.5.9 PTZ Control
If you mount the IP camera on pan-tilt camera cradles that support pan-tilt control via RS-485
connection, you can use this function to control pan-tilt camera cradle so you can control the
orientation of IP camera from remote place.
Enable RS-485 Check this box to enable RS-485 functionality.
Port Setting
Baud Rate: Select the baud rate of RS-485 interface that pan-tilt
camera cradle will accept. When the length of RS-485 connection is
very long (longer than 200M), it’s not recommended to use high
speed connection (greater than 2400bps).
Data Bits: Select data bits of RS-485 connection.
Parity: Select parity bit: None, odd, even, or space.
Stop Bit: Select stop bit as 1 or 2.
Use Pelco-D
Address
Select this option and RS-485 interface will output pan-tile control
signal in Pelco-D format. This format is widely accepted by most of
pan-tilt camera cradles. You have also input pan-tilt camera cradle’s
address code in ‘Address’ field. This code must be identical to
pan-tilt camera cradle’s address code.
Use Custom
Protocol
When the pan-tilt camera cradle does not support Pelco-D protocol,
you can define a protocol’s detail by this function.