PLANET EPN-102 - Manual (Page 8)

Rear Panel of EPN-102
Rear Panel Port and Button Definition
Connector Description
ON / OFF The power button is for turn on or turn off the ONU.
RESET
The reset button can restore the default settings of device. To restore factory
defaults, keep the device powered on and push a paper clip into the hole. Press
down the button over 5 seconds and then release.
PWR Power connector with 12V DC 1A
10/100
ONU is successfully connected to a device through the 10/100 Fast Ethernet port.
If the FE LED is flashing, the ONU is actively sending or receiving data over that
port.
10/100/1000
ONU is successfully connected to a device through the 10/100/1000 Gigabit
Ethernet port. If the GE LED is flashing, the ONU is actively sending or receiving
data over that port.
PON
The PON connector allows data communication between the ONU and the OLT
through a single mode fiber.
8