PLANET FGSD-910HP - Manual (Page 12)

12
Port Type Cable Type Connector
10Base-T Cat 3, 4, 5, 2-pair RJ-45
100Base-TX Cat.5 UTP, 2-pair RJ-45
1000Base-T Cat.5/5e/6 UTP, 4-pair RJ-45
Any Ethernet devices like hubs/PCs can connect to the FGSD-910P / FGSD-910HP
PoE Ethernet Switch by using straight-through wires. The nine RJ-45 ports are
auto-MDI/MDI-X, which can be used on straight-through or crossover cable.
2.3 Desktop Installation
To install the PoE Ethernet Switch on desktop, simply follow the following steps:
Step 1: Attach the rubber feet to the recessed areas on the bottom of the PoE
Ethernet Switch, as shown in Figure 2-5.
PoE
8-Port 10/100Mbps+1 G
igabit 802.3af
PoE Switch
FGSD-910P
1 PWR 2 3 4 5 6 7
Speed
10/100
LNK/ ACT
Gigabit
8 9
ACT LNK
8 9
7 6 5 4 3 2 1
Figure 2-5: Place the PoE Ethernet Switch on the Desktop
Step 2: Place the PoE Ethernet Switch on desktop near an AC power source.
Step 3: Keep enough ventilation space between the PoE Ethernet Switch and the
surrounding objects.
Note
When choosing a location, please keep in mind the environmental
restrictions discussed in Chapter 1, Section 4 under Specifications.