Avago Technologies MegaRAID SAS 9240-4i - Manual (Page 54)

LSI Corporation
- 54 -
MegaRAID SAS Device Driver Installation User Guide 
June 2014
Solaris 10 x86, Solaris 11, and Solaris Express x86 Driver Installation
Notes
8.7.4 Removing an Inbox Driver/Package on the Solaris 11 OS (Bootable LSI Controller)
Perform the following procedure to remove the inbox driver/package on the Solaris 11 OS that is on a bootable
LSI controller.
1. Become a super-user on your system.
2. Check to see which MegaRAID driver package is installed on your system by using the following command:
— # modinfo | grep mr_sas
To find the inbox mr_sas package name, run the following commands:
— #pkg list | grep mr_sas
— driver/storage/mr_sas ----> inbox mr_sas IPS packagename
3. If an inbox IPS package is installed, rename inbox driver files by using the following commands.
For x86 systems:
#mv /kernel/drv/mr_sas /kernel/drv/mr_sas.inbox
#mv /kernel/drv/amd64/mr_sas /kernel/drv/amd64/mr_sas.inbox
#mv /kernel/drv/mr_sas.conf /kernel/drv/mr_sas.conf.inbox
For SPARC systems:
#mv /kernel/drv/sparcv9/mr_sas /kernel/drv/sparcv9/mr_sas.inbox
#mv /kernel/drv/mr_sas.conf /kernel/drv/mr_sas.conf.inbox
4. Continue with the instructions in Section 8.6, Installing or Upgrading the Driver Package after OS Installation , to
complete the installation of the LSI driver package.
8.8 Notes
The following are known limitations:
 The mr_sas driver is not loaded (attached) in the Solaris 10 Update 4 version when you use certain controllers.
This issue is an OS limitation. This issue is fixed in Solaris 10-Update 5 and later.
 In the Solaris 11 OS, the action Install Time Update (ITU) of the driver is not supported. The Solaris 11 OS requires
IPS packaging; it does not support the legacy Solaris 10 OS ITU install method.