beautypg.com

Installing the clip on the remote mount board – Avago Technologies Cache Protection for RAID Controller Cards User Manual

Page 6

background image

LSI Corporation

- 6 -

MegaRAID CacheVault Flash Module 02 Quick Installation Guide
March 2012

MegaRAID CacheVault Flash Module 02 Quick Installation Guide

Attaching the CVFM02 Module to a RAID Controller and Connecting It to a CVPM02 Module

on a Remote Mount Board

g.

Secure the CVFM02 module to the RAID controller with the screws and the standoffs in the three screw holes.

The standoffs are threaded at both ends, and a screw goes into each end. The screw threads from the rear of
the controller board into the board-to-board standoffs on the bottom of the CVFM02 module.

Installing the Clip on the Remote Mount Board

Follow these steps to install the clip directly on the BBU-BRACKET-05 remote mount board.

1.

Make sure the remote mount board is on a flat, clean, static-free surface. Ground yourself, and make sure that the
system is grounded.

2.

Remove the clip and the remote mount board module from the package.

3.

Place the clip and the remote mount board module front-side-up on a flat, clean, static-free surface.

4.

Hold the clip so that the screw holes on the clip line up with the screw holes on the remote mount board, as
shown in the following figure.

Figure 3 Installing the Clip on the Remote Mount Board

5.

Secure the clip to the remote mount board in three screw holes with the screws and the nuts.

The screws thread through the front of the clip and the remote mount board.

NOTE Center the screwdriver carefully to avoid stripping the screw heads. Do not over-tighten
the screws.

NOTE Center the screwdriver carefully to avoid stripping the screw heads. Do not over-tighten
the screws.

CV Clip

3_00895a-00

This manual is related to the following products: