Emerson MICRO MOTION 1700 - Manual (Page 23)

Components of a 4-wire remote mount transmitter (stainless steel
housing)
Figure 3-4:
A
B
D
C
A. End cap
B. Cap screws
C. Transmitter
D. Mounting bracket
2. Attach the mounting bracket to an instrument pole.
3.2 Prepare the 4-wire cable
Important
For user-supplied cable glands, the gland must be capable of terminating the drain wires.
Note
If you are installing unshielded cable in continuous metallic conduit with 360º termination shielding,
you only need to prepare the cable – you do not need to perform the shielding procedure.
Mounting and sensor wiring for 4-wire remote installations
Installation Manual 19