Euphonix MC Control - Manual (Page 50)

professional control surface
Artist Series
USER GUIDE
EuControl
50
6.2 Workstations
An Artist device can control applications running on a second computer, referred
to in this guide as a workstation. The Workstations tab establishes the list of
workstations that the
WORKSTATION key cycles through. Any workstation run-
ning EuCon software can be in this list, including those controlled by the System
5-MC, MC Pro, and MC Control.
Figure 6-3 Workstations tab
All Workstations
All Workstations lists all EuCon-enabled workstations on the network. If the
workstation is already in the My Workstations list, it is shown in gray and cannot
be selected.
My Workstations
My Workstations lists the workstations that can be attached to by pressing the
WORKSTATION key.