Whelen C200A00E - Manual (Page 3)

Page 3
MOUNTING FOOT
TINNERMAN
NUT
FOOT
ANCHOR
PLATE
SET
SCREW
Plate slides into
lightbar extrusion
5" Mounting Foot
NUT
BOLT
SPLIT LOCK
WASHER
METAL SCREW
NOTE: The mounting straps are made to fit the contours of individual
vehicles. The strap
may look different. If your lightbar has a 5"
mounting foot, it will assemble differently than the standard
mounting foot. It also uses an extension to compensate for
the extra height. Follow these illustrations for assembly.
Mounting to the lightbar is the same.
shown here is for example only. The strap
for your vehicle
NOTE:
NOTE:
NOTE:
NOTE:
NOTE:
NOTE:
STRAP
S H E E T
M E T A L
SCREWS
EXTENSION
VEHICLE ROOF
Locking
Plate
Mounting
Foot
Nut
Mounting
Pad
Adjustment
screws
Lock
Washer
Anchor Plate Tinnerman
Nut
Tinnerman
Nut
Anchor
Plate
Locking
Plate
Mounting Strap
Mounting
Screw
Adjustable Foot
Model MKAJ
Standard Foot
Model MKEZ
Mounting
Strap
Mounting
Screw
Tension
Bolt
Tension
Bolt
Tighten
screws
with
torque
wrench
set
at 35
to 40
in/lbs
Model
MKAJ
Mounting
Foot
Allen
screws
Mounting
Foot Base
NOTE: Model MKAJ is an adjustable mounting foot. On this model you
may loosen the screws on the rear of the foot and adjust the angle of the
lightbar. This feature can be used if the angle of the roof is not level with the road. IMPORTANT: To adjust the leveling screws you must use a
torque wrench set at 35 to 40in./lbs.
1/2" MIN. CLEARANCE
NOTE: Unless otherwise specified, the lightbar mounting feet must be sitting as close to the edge of the roof as possible. They must also be
in full contact with the roof and not be hanging off the edge.
IMPORTANT: For strap mounted bars, be sure you have the right sized
lightbar for your vehicle. The lightbar should be approximately the same
width as the vehicle roof. If too large or small it will not mount properly
to the vehicle and may come loose during driving.