Whelen PROGRAM1 User Manual

Automotive

Page 1

POWER

TEST

START

S/L

READY

888

RED.........

BLACK....

To +12VDC

To Ground

RED...........

BLACK......

WHT/VIO...

To (+) Lighthead Input

To (-) Lighthead Input

To ScanLock™ Input

ENGINEERING COMPANY INC.

51 Winthrop Road
Chester, Connecticut 06412-0684
Phone: (860) 526-9504
Fax: (860) 526-4078
Internet: www.whelen.com
Sales e-mail: [email protected]
Canadian Sales e-mail: [email protected]
Customer Service e-mail: [email protected]

Automotive:

Operational Guide:

LED Lighthead Pattern Programmer

1. Connect the programmer to the lighthead using the

information in the wiring diagram shown. The ‘READY”
LED indicator will be lit when the programmer has been
properly connected to a +12VDC power source.

2. Rotate the knob until the number of the desired pattern

(found in the installation guide included with your
lighthead) is shown on the display.

3. Press the “START” button to begin programming the

lighthead to the selected pattern. During the
programming process the following will occur:

• The ready LED will go off.
• The programmer resets the lighthead to pattern #1
• The “POWER” LED will be lit to indicate that power is

being provided to the lighthead.

• The S/L (ScanLock) LED will flash to indicate that the

programmer is scanning through the patterns

• The display will count down the number of patterns

remaining until the selected pattern has been reached.

4. When programming process is complete, the lighthead

will display the new pattern for approx. 5 seconds. The
lighthead will then turn off, the POWER and S/L
indicators will turn off and the READY LED will be lit.

5. Press the “TEST” button to momentarily turn on the

lighthead and display its current pattern.