Whelen SAK47 - Manual (Page 2)

Page 2
BUMPER
Tow Hook
Fig. 4
ADD WASHERS
Fig. 4
This bracket mounts to either the left or right side front of the
vehicle near the bumper using 3 existing studs where the tow hook mounts to the frame (Fig. 3).
1. Remove the 3 nuts holding the tow hook in. Save the nuts for re-mounting the bracket (Fig. 3).
2. Mount the bracket to the
vehicle by re-installing two
of the vehicles nuts, adding
the 4 supplied 9/16 flatwashers
as shown in figure 4. Also, be sure to insert the third mounting stud into the top
hole in the bracket.
3. Re-install the third nut to the stud coming through the top of the bracket securing
the bracket to the vehicle (Fig. 5). NOTE: Figures 4 & 5 show the bracket
without the speaker for illustrative purposes. The speaker should be
mounted before installing the bracket.
4. Extend the WHITE (positive) and BLACK (negative) speaker wires to your siren
amplifier and refer to the amplifiers instructions for connections
Tow Hook
Fig. 5 Fig. 5
BUMPER
Tow Hook
Fig. 4
ADD WASHERS
Fig. 4
This bracket mounts to either the left or right side front of the
vehicle near the bumper using 3 existing studs where the tow hook mounts to the frame (Fig. 3).
1. Remove the 3 nuts holding the tow hook in. Save the nuts for re-mounting the bracket (Fig. 3).
2. Mount the bracket to the
vehicle by re-installing two
of the vehicles nuts, adding
the 4 supplied 9/16 flatwashers
as shown in figure 4. Also, be sure to insert the third mounting stud into the top
hole in the bracket.
3. Re-install the third nut to the stud coming through the top of the bracket securing
the bracket to the vehicle (Fig. 5). NOTE: Figures 4 & 5 show the bracket
without the speaker for illustrative purposes. The speaker should be
mounted before installing the bracket.
4. Extend the WHITE (positive) and BLACK (negative) speaker wires to your siren
amplifier and refer to the amplifiers instructions for connections
Tow Hook
Fig. 5 Fig. 5