Whelen SAK47 User Manual
Automotive: sirens & switches, Danger
Page 1
1/4 - 20 X 1-1/4"
HEX HEAD SS
9/16
FLATWASHER
1 / 4 "
S P L I T
LOCKWASHER
Fig. 2
1/4 - 20 X 1-1/2"
HEX HEAD SS
©2013 Whelen Engineering Company Inc.
Form No.14668 (01213)
Installation Guide:
SA315 Siren Speaker Mounting Bracket
for 2011 to 2012 Dodge Ram 1500
®
ENGINEERING COMPANY INC.
51 Winthrop Road,
Chester, Connecticut 06412-0684
Phone: (860) 526-9504
Fax: (860) 526-4078
Automotive:
Sirens & Switches
Internet: www.whelen.com
Sales e-mail: [email protected]
Canadian Sales e-mail: [email protected]
Customer Service e-mail: [email protected]
For warranty information regarding this product, visit www.whelen.com/warranty
Installation 2011 - 2012 Ram 1500:
First, mount the speaker to the
bracket. The SA315 is shipped
with two 1/4-20 X 1-1/4” Hex
Head Screws (A) (Figs. 1 & 2). A
short screw must be used in the
hole that does not go through the
bracket so it will properly secure
the driver to the housing. The
longer screws included in the
mounting kit are necessary to go
through the mounting bracket,
the siren housing and into the
siren driver. If for any reason you
need to remove all 4 screws at once be sure to hold the driver
securely in place. IMPORTANT: For drainage purposes, the
speaker must be oriented so that the
wire passage hole is in the “6
o’clock” position (closest to
the road).This is
also the drain
hole for the
siren.
Improper
mounting will result in
premature driver
failure and
void the
product
warranty.
Sirens produce extremely loud emergency warning tones! Exposure to these tones without
proper and adequate hearing protection, could cause ear damage and/or hearing loss! The Occupational Safety &
Health Administration (www.osha.gov) provides information necessary to determine safe exposure times in
Occupational Noise Exposure Section 1910.95. Until you have determined the safe exposure times for your
specific application, operators and anyone else in the immediate vicinity should be required to wear an approved
hearing protection device. FAILURE TO FOLLOW THIS RECOMMENDATION COULD CAUSE HEARING LOSS!
DANGER!
wire
exit &
drain
hole
A
A
SA315 / Rear View
Fig. 1
1/4 - 20 X 1-1/4"
HEX HEAD SS
9/16
FLATWASHER
1 / 4 "
S P L I T
LOCKWASHER
Fig. 2
1/4 - 20 X 1-1/2"
HEX HEAD SS
©2013 Whelen Engineering Company Inc.
Form No.14668 (012113)
Installation Guide:
SA315 Siren Speaker Mounting Bracket
for 2011 to 2012 Dodge Ram 1500
®
ENGINEERING COMPANY INC.
51 Winthrop Road,
Chester, Connecticut 06412-0684
Phone: (860) 526-9504
Fax: (860) 526-4078
Automotive:
Sirens & Switches
Internet: www.whelen.com
Sales e-mail: [email protected]
Canadian Sales e-mail: [email protected]
Customer Service e-mail: [email protected]
For warranty information regarding this product, visit www.whelen.com/warranty
Installation 2011 - 2012 Ram 1500:
First, mount the speaker to the
bracket. The SA315 is shipped
with two 1/4-20 X 1-1/4” Hex
Head Screws (A) (Figs. 1 & 2). A
short screw must be used in the
hole that does not go through the
bracket so it will properly secure
the driver to the housing. The
longer screws included in the
mounting kit are necessary to go
through the mounting bracket,
the siren housing and into the
siren driver. If for any reason you
need to remove all 4 screws at once be sure to hold the driver
securely in place. IMPORTANT: For drainage purposes, the
speaker must be oriented so that the
wire passage hole is in the “6
o’clock” position (closest to
the road).This is
also the drain
hole for the
siren.
Improper
mounting will result in
premature driver
failure and
void the
product
warranty.
Sirens produce extremely loud emergency warning tones! Exposure to these tones without
proper and adequate hearing protection, could cause ear damage and/or hearing loss! The Occupational Safety &
Health Administration (www.osha.gov) provides information necessary to determine safe exposure times in
Occupational Noise Exposure Section 1910.95. Until you have determined the safe exposure times for your
specific application, operators and anyone else in the immediate vicinity should be required to wear an approved
hearing protection device. FAILURE TO FOLLOW THIS RECOMMENDATION COULD CAUSE HEARING LOSS!
DANGER!
wire
exit &
drain
hole
A
A
SA315 / Rear View
Fig. 1