Whelen SABKT24 - Manual (Page 2)

Page 2
CAUTION
Loud siren noise can cause
hearing damage and/or loss.
Refer to OSHA Section 1910.95 prior
to putting ANY siren into service!
Wear
Protection!
ACTIVATION OF THIS
SIREN MAY DAMAGE
UNPROTECTED EARS!
5. Secure the bottom of the bracket (with speaker) to the vehicle using the existing hardware.
Secure the top of the bracket to the riv-nut you installed in step 2 using the supplied
mounting hardware Fig. 4).
6. Extend the WHITE (positive) and BLACK (negative) speaker wires to your siren amplifier
and connect as shown in the amplifiers instructions. Test the siren to confirm proper
operation.
7. Re-install the protective cover to complete this installation. Test all vehicle components and
equipment before returning the vehicle to service.
IMPORTANT! It is the responsibility of the installation technician to make sure that the
installation and operation of this product will not interfere with or compromise the
operation or efficiency of any vehicle equipment! Before returning the vehicle to active
service, visually confirm the proper operation of this product, as well as all vehicle components and equipment.
DANGER!
Sirens produce extremely loud emergency warning tones!
Exposure to these tones without proper and adequate hearing protection, could
cause ear damage and/or hearing loss! The Occupational Safety & Health
Administration (www.osha.gov) provides information necessary to determine
safe exposure times in Occupational Noise Exposure Section 1910.95. Until you
have determined the safe exposure times for your specific application, operators
and anyone else in the immediate vicinity should be required to wear an
approved hearing protection device. FAILURE TO FOLLOW THIS
RECOMMENDATION COULD CAUSE HEARING LOSS!
CAUTION
Loud siren noise can cause
hearing damage and/or loss.
Refer to OSHA Section 1910.95 prior
to putting ANY siren into service!
Wear
Protection!
ACTIVATION OF THIS
SIREN MAY DAMAGE
UNPROTECTED EARS!
1. Secure the bottom of the bracket (with speaker) to the vehicle using the existing hardware.
Secure the top of the bracket to the riv-nut you installed in step 2 using the supplied
mounting hardware Fig. 4).
2. Extend the WHITE (positive) and BLACK (negative) speaker wires to your siren amplifier
and connect as shown in the amplifiers instructions. Test the siren to confirm proper
operation.
3. Re-install the protective cover to complete this installation. Test all vehicle components and
equipment before returning the vehicle to service.
IMPORTANT! It is the responsibility of the installation technician to make sure that the
installation and operation of this product will not interfere with or compromise the
operation or efficiency of any vehicle equipment! Before returning the vehicle to active
service, visually confirm the proper operation of this product, as well as all vehicle components and equipment.
DANGER!
Sirens produce extremely loud emergency warning tones!
Exposure to these tones without proper and adequate hearing protection, could
cause ear damage and/or hearing loss! The Occupational Safety & Health
Administration (www.osha.gov) provides information necessary to determine
safe exposure times in Occupational Noise Exposure Section 1910.95. Until you
have determined the safe exposure times for your specific application, operators
and anyone else in the immediate vicinity should be required to wear an
approved hearing protection device. FAILURE TO FOLLOW THIS
RECOMMENDATION COULD CAUSE HEARING LOSS!