RIGOL DS6000 Series - Manual (Page 47)

RIGOL
User’s Guide for RP7000 Series Active Probe 11
2. Solder-in Probe Head
Solder-in probe head includes two types: solder-in differential probe head
and solder-in single-ended probe head as shown in Figure 7 and Figure
8. Wherein, solder-in differential probe head is suitable for measurement of
high-density IC pin signals.
Figure 7 Solder-in Differential Probe Head
Figure 8 Solder-in Single-ended Probe Head
When using the solder-in probe head for measurement, please use auxiliary
device to fix the probe head. Do not use your hand to fix the probe head, or
else, the lead resistor soldered onto the probe head might break or fall off,
what’s more, the hand-held position might also affect the probe performance.
Wherein, the nickel wire of the solder-in probe head is a standard accessory. If
the nickel wire under use became damaged or break off, please replace it with
an appropriate lead resistor (refer to To Replace Probe Accessories).
Mark Sleeve of Negative Pole
Nickel Wire
Nickel Wire