Retrotec Cloth Door Panel - Manual (Page 2)

1
4
5
2
6
3
1 2
1 2 4 3
1
4
5
2
6
3
1 2
6
4 3
5
QuickGuide Cloth Door Panel
Step 1: Secure the door
● Select a doorway, between 29” to 44” (74cm to
112cm) in width, and 53”
to 97” (134cm to 247cm)
in height. (For large frames,
width must be 32” to 51”
(81cm to 130cm) and height
59” to 109” (150cm to
277cm)).
● The door must be
held open secure ly
during testing.
Step 2: Unpack the Aluminum Frame
● Remove the frame pieces from the case.
● A complete set includes one cloth panel, two long and
two short frame parts, two crossbars, and a fan strap
(attached to crossbar).
● Optional crossbar/frame extenders or cloth panels can
be ordered if required.
Step 3: Lay out the pieces
● Arrange the aluminum frame sections on the floor.
● Match the corners according to the numbers stamped
on each section.
● Ensure all cam levers are “unlocked” (cam handles
should be parallel to frame).
Step 4: Assemble the corners
● Slide the corners together until they snap into position.
● Loosen all four black knobs to allow the frame
sections to be resized.
Step 5: Size the frame to the doorway
● Position the frame in the doorway, and extend the
frame until each side is in contact with the door frame.
● Tighten the black knobs but leave the cam levers
in the “unlocked” position.
● Insert and extend the crossbars into slots at position
‘5’ and ‘6’.
Tip: If any of the pieces are loose, use the included Allen
Key to tighten the screws.
Tip: Fit the frame so that it is tight enough to remain standing
in the doorway, but can be removed with a slight pull.
Page 2 of 3
1
1 2
2
6 6
5
3
3 4
4
5