Retrotec DM32 User Manual
Page 6
Page 6 of 16
©Retrotec Inc. 2013
4. Automatically finds gauges connected to the computer USB
Any gauges connected to the computer running the DM32 Configurator software via direct USB cable
connection will be found when the DM32 Configurator is started, as shown in Figure 4.
Figure 4: Finds gauges connected to this computer via USB
If the gauge is using an older version of firmware than the Configurator finds on the Retrotec website
(automatically), then a yellow exclamation mark shows up in the list next to the name of the gauge, as
shown in Figure 5. When a gauge is selected, it is highlighted in blue, and the details of its Firmware
Version and Calibration Date show at the bottom of the list as shown in Figure 6.
Figure 5: If a gauge has old firmware, the yellow ! will show up beside the serial number in the list
Figure 6: Firmware version and calibration date for selected gauge show under the list