Retrotec DM32 User Manual
Page 16
Page 16 of 16
©Retrotec Inc. 2013
Figure 20: Some Secure WiFi networks need you to change the defaults in Advanced security settings
12. Click "Save to Gauge". If you want the same parameters entered into all gauges in the list, click
“Copy to All Gauges”. User is notified as shown in Figure 21 when the gauge or gauges are
updated.
13. Disconnect the gauge from the PC.
Figure 21: User is notified when the gauge is successfully updated with WiFi network parameters
The secure networking parameters are now set into the gauge(s). Follow the next steps to verify:
1. On the gauge itself, tap [Settings].
2. Tap […] and then tap [Network]
3. Tap the [Status] key at the top of the screen to cycle Network Status choices, until it says "WiFi".
4. Verify that the DM32 has obtained a network address by checking the [IP address] key for an IP
address that is valid on your network.
5. Tap the [Home] key to get out of the “Network settings” screen.