RISCO Group ProSYS, Interactive Voice Module - Manual (Page 22)

22
Voice Module Programming and Operations Manual
3.
Enter the 4- or 6-digit user code you usually enter in the system
keypad, followed by
#
.
NOTE:
If an invalid user code is entered, the following message is announced:
Wrong code.
If a valid user code is not entered within 10 seconds, the system hangs up, and the call
must be made again, as described in step 1.
If 3 invalid user codes are entered within 10 minutes, the system hangs up and is then
locked for fifteen minutes. During this time, any calls initiated to the system are not
picked up. However, it is still possible to receive event calls from the system.
The Status message is announced, followed by the
Operations
menu, as described on page 23.
You can now perform the required remote operations, as described
in the subsequent sections of this manual.
TIPS:
To repeat the Status message, press # .
To bypass further menus and go directly to your required operation, use the list of quick
key combinations on page 20.
Status Messages
When a valid user code is entered, the Status message is
announced, declaring the current status of the system.
The following is a list of possible Status messages:
All partitions are armed.
All partitions are ready to arm.
Intruder alarm in [partition x] / all partitions.
Fire alarm in [partition x] / all partitions.
Emergency alarm in [partition x] / all partitions.
Panic alarm in [partition x] / all partitions.
[Partition x] is armed.
[Partition x] is ready to arm.
[Partition x] is not ready to arm.
The Status message declares the status of the partitions to which you
have access. If partition status varies, the Status message includes a
separate message for each partition.
The default message for a partition is
partition x
where
x
is the
partition number. See page 12 for details about recording a name,
such as
Living Room
for each partition.