RISCO Group ProSYS, Interactive Voice Module - Manual (Page 12)

12
Voice Module Programming and Operations Manual
Recording and Playing Messages
*
9 CODE # 4 2
You can record a Common message for the system and a message
for each Partition, Zone or Utility Output.
Recording the Common Message
*
9 CODE # 4 2 1
The following procedure describes how to record an identification
message for your premises.
To record the Common message:
1.
VOICE MESSAGE:
1) MSG. STRUCTURE
VOICE MESSAGE:
1) MSG. STRUCTURE
From the Voice Message menu, select [2]
Play/Record .
2.
PLAY/RECORD:
1) COMMON MSG.
PLAY/RECORD:
1) COMMON MSG.
Select [1] Common Msg.
3.
COMMON MSG:
1) PLAY
COMMON MSG:
1) PLAY
Select [2] Record .
4.
PRESS # TO START
MESSAGE RECORD
PRESS # TO START
MESSAGE RECORD
Press /
==
and say your message into
the appropriate microphone.
= NOTE:
A microphone is located in both the Voice module and in each MBU. Ask your installer
which microphone should be used for recording messages.
5.
PRESS # TO STOP
REC. TIME: 10
PRESS # TO STOP
REC. TIME: 10
The counter in the bottom right of the LCD
counts down the seconds remaining until the
system stops recording.
Recording stops automatically after 10 seconds. If you finish your
message in 9 seconds or less, press /
==
to stop
recording.
= NOTE:
Not pressing /
==
immediately after finishing recording your message might
cause unwanted noises or a long silence in your message.