RISCO Group ProSYS Version 7.xx - Manual (Page 15)

ProSYS Version 7.XX - Supplementary Instructions 15
Quick Keys Parameter Default Range
The following table describes how the three MSs use the primary,
secondary and backup time intervals in the various MS report split
options.
MS report
split for
urgent
events MS #1
Polling
State MS #2
Polling
State MS #3
Polling
State
DO NOT
CALL N/A N/A N/A
CALL 1
ST
Primary N/A N/A
CALL 2
ND
N/A Primary N/A
CALL 3
RD
N/A N/A Primary
CALL ALL Primary Primary Primary
1
ST
BKUP
2
ND
Primary If (MS#1 is OK)
Secondary
Else (MS#1
Failed)
Backup N/A
1
ST
BK
2
ND
3
RD
Primary If (MS#1 is OK)
Secondary
Else (MS#1
Failed)
Backup If (MS#2 is OK)
Secondary
Else (MS#2
Failed)
Backup
1
ST
BK 3
CALL2
Primary Primary If (MS#1 is OK)
Secondary
Else (MS#1
Failed)
Backup
2
ND
BK 3
CALL1
Primary Primary If (MS#2 is OK)
Secondary
Else (MS#2
Failed)
Backup
Important note:
The installer must manually enter the report code value of 87 under the Report
Codes programming menu using quick keys [6][8][0][4]. This value represents
SIA code ZZ and Contact ID code 999 that are used to validate the report
process.
[5][0][4][1] IP Primary 00003 (x10
sec) 0-65535 sec
Defines the polling interval through the primary channel. When using
the default time, a polling message is sent every 30 seconds.
When the IP Primary polling time is defined as 0, no polling message
is sent to the MS (when the MS channel is in the Primary polling
mode).