RISCO Group ProSYS Version 7.xx - Manual (Page 13)

ProSYS Version 7.XX - Supplementary Instructions 13
Bus Detector Naming Conventions
The following table contains the names of the various Bus detectors and their
corresponding Installer programming menu codes under the Type field, when
adding a new Bus zone to the system.
Bus Detector TYPE Field Option
in Previous Versions TYPE Field Option
in Version 7 and above
WatchOUT DT ODT15 ODT15
WatchOUT PIR OPR12 OPR12
Industrial LuNAR LUNR Cannot be selected,
Replaced by Industrial
LuNAR Grade 3.
Industrial LuNAR Grade 3 LUNG3 ILun3
WatchIN IDT25 WatIN
iWISE DT G2 Bus 15m,
25m
N/A iDTG2
iWISE QUAD G2 Bus N/A iQDG2
iWISE DT G3 Bus 15m,
25m
N/A iDTG3
iWISE QUAD G3 Bus N/A iQDG3
New Firmware Capabilities
The information in this section describes new capabilities in the ProSYS firmware
and new parameters under the Installer programming menu.
Tamper Test during Exit Programming
When exiting the Installer Programming menu, ProSYS will check if there are any
existing tamper faults in the system. A list of these tamper faults will appear. The
installer can select whether to confirm exiting the programming mode with a
tamper condition and by this a tamper alarm can occur or fix the tamper faults.
WatchOUT Proximity Anti Mask in WatchOUT extreme
WatchOUT DT version B (P/N RK325DT00xxB) has a new proximity anti masking
capability in addition to its improved IR anti masking capability.
When the WatchOUT DT is installed as a Bus zone, in order to enable Proximity
Anti-Mask the following parameters must be programmed:
Zones Miscellaneous: Bus Zone - WatchOUT
Quick Keys Parameter Default Range
[2][0][3][zz]
[8] Prox Anti Mask Enable
Defines the operation of proximity anti masking detection.
[1] Disable [2] Enable