RISCO Group GT490X - Manual (Page 15)

Common Options With Menu Numbers
You are able to jump to various common options when programming by
entering the relevant menu numbers. With a Header showing, key in the
appropriate menu number, then press Yes.
For a full list of Common Options please refer to the GT490X
Engineer’s Reference Guide which is available on the web site.
Menu Item
12 Full Set Setting Time / Setting Mode
22 No. of Keypads / Multi On Off / K/Switch
28 Entry Time 1
34 Digicom Type
38 Engineer Code
46 Main Fail Delay
47 Tamper / Fault Reset Mode
50 Zone Response
52 Zone (Attributes)
155 Confirm Time Window (BS8243 Section)
139 PSU Test Time
Note: If any Zones (panel or expander zones) are not used the terminals for that
Zone should be left open (no link) and the Zone should be programmed as Off
Page 14
Blue
Grey
Red
Brown
6K8
Brown
Blue
Orange
Brown
16K
Red
Violet
Orange
Brown
27K
Yellow
Violet
Red
Brown
4K7
Brown
Red
Orange
Brown
12K
Resistor Colour Codes
Fig.8
PR5846 Rev12 490X QS Eng.qxd 10/05/2012 11:39 Page 15