RISCO Group GT490X - Manual (Page 14)

Panic / Duress
PA Mode / Bells Only / Bells Always
Silent Always / Bells if Line Fault
Testable / Non-Testable
PA Confirm
(PA Confirm is defaulted to Off).
Off/8Hr/10Hr/12Hr/14Hr/16Hr/18Hr/20Hr.
Duress Off (To conform with EN
standards, Duress is defaulted to Off and
cannot be changed)
Program PGM 2 / 3 / Timers...
PGM2/3 Operating Mode
PGM2 Mode
PGM3 Mode
Timer 1 On Time
Timer 1 Off Time
Program Reset / Mains...
Mains Fail Delay
Alarm Reset
Tamper Reset
Fault Reset
Alarm Restore On/Off
Abort Time
Program Sounder Levels...
Chime Level
Entry / Exit Level
Key Beep Level
Program PGM1
PGM 1 O/P
Custom Output 1- 8
Program Engineer Code...
Code
Lock / Unlock
Program Service...
Mains OK 50Hz
Save Panel NVM to PTM
Load Panel NVM to PTM
Service Timer
Time To Next Service
Service Tel No.
Lock-Out On/Off
Engineer Mode Constant/Time
d
Program Custom Screens...
LCD Status Display
(To conform with EN standards, LCD
Status is defaulted to Off and cannot be
changed).
LED Status Display
Custom Display On / Off
Program Custom Text
Program Diagnostics / Log...
List Event Log
Change List Diagnostics
PSU Diagnostics
NovActive Diagnostics
PSU Test Time
Change / List Test Limits
Aux Volts
Battery Volts On Charge
Battery Volts Off Charge
Program Alarm Confirm...
Confirm Window Time
Confirm On Entry
Confirm Sounder Mode
Confirm Reset Mode
Confirm Secondary Time
Confirm ET Mode
Confirm Bell Mode
Confirm Strobe Mode
Confirm Start Delay
Confirm Comms Restore
Confirm Keypad Opening
Confirm ACE Battery Monitor
Page 13
PR5846 Rev12 490X QS Eng.qxd 10/05/2012 11:39 Page 14