Evolve Communications RD5000 - Manual (Page 9)

8 *Trademark
Note A Low Battery icon appears on the top of all display screens when
the battery power is low.
Getting Started
1. Activate Remote Control
Install Batteries
The battery cover is located on the back of the remote. Pay close attention to the
direction of the batteries, making sure the poles (+ and -) are aligned as indicated in
the battery compartment.
Remove battery case cover to install the batteries in the remote control:
Press firmly on the arrow on the back of the remote to remove the battery
cover.
Insert four new 1.5-volt AA alkaline batteries, taking care to align the
poles ( + and - ) as indicated in the battery compartment.
Close the battery cover.
Note The batteries in your GUIDE Remote* should last about three months,
depending on how much you use it. If the remote will not be in use for three
or more weeks, it is suggested that you remove the batteries to avoid
damage to the remote.
Note Your remote will not lose its device settings when you remove and reinstall
batteries. However, you will need to either sync your remote or set the time
and date manually (see page 42) for your remote to work properly.
1
2
Activate Remote Control
1.5-volt AA alkaline
3