Evolve Communications RD5000 - Manual (Page 43)

42 *Trademark
Using the Remote
Time and Date
The time and date are accurately updated automatically each time you sync your
GUIDE Remote
*. Additionally, you may set the time and date manually, for instance
if batteries are removed and replaced.
To set the time and date manually, perform the following steps:
1
2
Press the MENU key and SELECT Remote Settings > Time and Date
Highlight Set Time and Date
and press the SELECT key.
Note If you choose Display Time and Date you will only be able to view the time
and date and not adjust them.
4
Press the Up / Down Arrow
key to adjust the numbers.
Press the Left / Right Arrow
key to change the cursor
position. (blinking indicates
cursor position)
Press the SELECT key when
you’re finished.
Note When you see the alert screen: “TIME AND DATE RESET,” you can set the
time and date as described in this section. However, we recommend that
you sync your remote at
www.GuideRemote.com for the most accurate
setting.
3
Read and follow the
instructions on the screen.
Press the Right Arrow key to
continue.
Using the MENU Key