Evolve Communications RD5000 - Manual (Page 11)

10 *Trademark
Note If you have more than one serial port, make sure that the RemoteLinker*
software is configured to the one that you’re using. To access COM port
settings, right-click on the
RemoteLinker icon located in the lower right
hand corner of your computer screen. Choose Settings. Select the correct
COM port to which you will be connecting the cable and click Apply.
Connect RemoteLinker* Cable
Before you connect the RemoteLinker* cable, you should determine the COM
port to which you will be attaching the cable. If your computer is on, perform the
shutdown procedure recommended by the manufacturer and turn it off. Turn your
computer back on after connecting the cable as indicated below.
Getting Started
Connect the small end of the cable to
the bottom of your GUIDE Remote.
Connect the large end of the cable
to the PC serial port.
Activate Remote Control