Select done when you are finished making changes, Viewing your ota channels, Connecting to a tv using the channel 3-4 output – EchoStar Over-the-Air Module MT2 User Manual
Page 8: Tv u
Page 7
6.
Select a channel and then select
Edit Name
to change the way the
channel name displays in the Program Guide and other channel
lists. You can rename only one channel at a time.
7.
Use the on-screen keyboard to enter the channel name.
8.
Select
Done
when you are finished making changes.
Viewing Your OTA Channels
The over-the-air channels that are scanned into the receiver using the
previous steps can be viewed in the on-screen Program Guide below
channel 100. The OTA channels are listed in yellow in the Program
Guide.
Note
: You will need to have satellite signal and subscribe to DISH
Network programming to view channels received using the OTA
Module. Guide information for over-the-air channels displays only if
you are subscribed to DISH Network local channels.
C
ONNECTING
TO
A
TV U
SING
THE
C
HANNEL
3-4 O
UTPUT
Use the
C
H
3-4 O
UT
connection to connect to a nearby TV using coax
cable. The TV connected to the Channel 3-4 output views the same
programming as your TV1 viewing location. Refer to your receiver
User’s Guide for more details on the TV1 viewing location.
1.
Install the module into the receiver using the instructions on page 3.
2.
Connect one end of a coax cable to the
C
H
3-4
O
UT
connection of
the module.
3.
Connect the other end of the coax cable to a coax connection on
your TV. This connect may be labeled
A
NTENNA
I
N
,
C
ABLE
I
N
, or a
OTA Module.book Page 7 Thursday, July 3, 2008 4:35 PM