EchoStar Over-the-Air Module MT2 - Manual (Page 7)

Page 6
Setting up the Receiver to Display OTA Channels
1. Using the remote control, press MENU, select System Setup ,
then Local Channels .
Note : Your Local Channels screen may differ slightly.
Figure 2. Local Channels Screen
2. Scan for channels by selecting Scan Locals .
Note : Ensure the Analog Type on the HDTV Setup menu (accessed
by MENU, System Setup , then HDTV Setup) is set to Offair .
3. The scan takes a few minutes to complete. If you want to stop the
scan before it is completed, select
Cancel . When the scan
completes, the results show how many digital over-the-air channels
were found.
4. Select OK to go back to the Local Channels screen and view the list
of channels.
5. If you want to name the over-the-air channels, follow the steps
below. Otherwise, select
Done to save the channel list.
OTA Module.book Page 6 Thursday, July 3, 2008 4:35 PM