Edimax Technology Edimax PS-3103P - Manual (Page 70)

63
Lines should be indented with tabs.
Where hostname is the device name of a print server,
the ht=1 tag specifies the hardware type is Ethernet, the
ha= tag specifies the Ethernet address of a print server,
which is the Node ID located on the print server. The ha
tag must be preceded by the ht tag. The ip= tag should
correspond to the IP address you want to assign to the
print server.
For example, a print server with the following
configuration:
Node ID: 0000B4010101 (this implies Ethernet
address is 0000B4010101),
IP address: 203.66.191.12
The entry for this print server in the /etc/bootptab file
should be:
PS010101:\
:ht=1:\
:ha=0000B4010101:\
:ip=203.66.191.12: