Powerfix Z31361 - Manual (Page 15)

15 GB/IE
Practical information regarding the use and care of lashing straps
lashing force after entering warm regions.
8. Lashing straps must be taken out of use or returned to the manufacturer
for repair if they show any signs of damage. The following points are
considered to be signs of damage:
–for webbing (that must be taken out of use): tears, cuts, nicks and
breaks in load-bearing fibres and stitches; deformations resulting from
exposure to heat.
–with end fittings and tensioning devices: deformations, cracks,
pronounced signs of wear, signs of corrosion. Only lashing straps
bearing identification labels shall be repaired. If there is any
accidental contact with chemical products, the lashing strap must be
removed from service and the manufacturer or supplier consulted.
9. Care should be taken that the lashing strap is not damaged by the
sharp edges of the load on which it is used. Regular visual inspection
before and after each use is recommended.
10. Only legibly marked and labelled lashing straps may be used.
11. Lashing straps must not be overloaded: The maximum hand force of
500 N (50 daN on the label; 1 daN 1 kg) may be applied with only
one hand. Mechanical aids such as bars or levers etc. may not be
used unless they are part of the tensioning device.