Assembly and connection – Powerfix PBMP 30 A1 User Manual
Page 38
- 35 -
Assembly and connection
Assemble the mounting
y
with the clamp fastening
t
onto a work surface,
as shown in figure B.
Alternatively, the mounting
y
can also be secured to a work surface
with screws (assembly material not supplied).
When using a gear-wheel chuck and the short drive
shaft e...
Screw the short drive shaft
e
onto the drive shaft
w
of the pump
q
.
Insert the electric drill
u
with the chuck into the mounting
y
.
Now push the pump
q
onto the mounting
y
so that the drive shaft
e
projects into the chuck and the pins of the mounting
y
are located in the
reception holes on the pump
q
.
Now tighten the chuck with the chuck key through the recess
i
so firmly
that the pump
q
can no longer release itself from the mounting
y
.
Tighten the cross-headed screw on the mounting
y
firmly, so that the drill
u
cannot jolt around.
Attach the suction hose to the connection
o
and the pressure hose to the
connection
a
. Pay heed to the direction of flow
detailed on the
pump
q
.
When using a quick-release chuck and the short drive
shaft e...
Secure the short drive shaft
e
into the chuck.
Insert the electric drill
u
, with the pre-assembled drive shaft
e
in the
chuck, into the mounting
y
.
Securely tighten the cross-head screw on the mounting
y
so that the drill
u
is being firmly held.
IB_75640_PBMP30A1_LB2.qxd 06.06.2012 12:08 Uhr Seite 35