Powerfix Z30225 - Manual (Page 15)

13 GB
Use / Troubleshooting
Move the On / Off switch 9 into position “ON” to
switch on the LEDs 20 .
Note: The LED bulbs 20 are non-replaceable.
Point the precision engineer’s LED magnifying glass 1
with the LED lamps 20 at the clamped work piece.
Release the alligator clips 18 in order to remove the
work piece.
Move the On / Off switch 9 into position “OFF” to
switch off the LEDs 20 .
Changing the Batteries
Pull the battery compartment cover 3 in the direction of
the arrow to remove it from the battery compartment 4 .
Take out the old batteries.
Place the new batteries 21 of type 1.5 V , AAA into
the battery compartment 4 .
Note: Ensure the correct polarity. This is shown in the
battery compartment
4 .
Push the battery compartment cover 3 back in the
opposite direction to the arrow back in order to close the
battery compartment
4 .
Q
Troubleshooting
 = Problem
 = Cause
 = Solution
66454_pow_Feinmechaniker_LED_Lupe_content_LB4.indd 13 25.05.11 17:26