Powerfix Z31403A - Manual (Page 3)

3 GB
Hollow Wall Anchor Set
Intended use
For fastening to drywall, gypsum fibre board, void
ceilings and chipboard. For private use only. The
product is not intended for commercial use. The
manufacturer is not liable for damage caused by
improper use.
General safety instructions
PLEASE READ THE INSTRUCTIONS FOR USE
PRIOR TO USE! PLEASE KEEP THE INSTRUCTIONS
FOR USE IN A SAFE PLACE! PLEASE INCLUDE
ALL DOCUMENTATION WHEN PASSING THIS
PRODUCT ON TO OTHERS.
This product is not a toy. Keep out of the reach
of children.
Check the product for damage before use.
Never use a damaged product.
Anchor size, borehole diameter and wall thick-
ness must be matched correctly. Please refer to
the sizing chart below!
An anchor‘s load capacity also depends on
the load capacity of the wall material. Please
contact the manufacturer of the wall material to
be sure. Do not overload the anchor to prevent
injuries and damage.
Maintain a minimum spacing of 10–15 cm
between mounting points to prevent the wall
material from tearing.
Wear protective glasses!
Be sure to secure the mounted object without
tolerance.
Checking the wall thickness
You may check the thickness of the wall by bending
the end of a thin wire about 2–4 mm and inserting
the bent wire into the borehole. Hook the wire to
the back of the wall and use a pen to mark the
borehole (Fig. B). By determining the wall thickness
you will now be able to select a suitable anchor.
Disposal
The packaging is made of environmentally
friendly materials, which may be disposed
through your local recycling facilities.
Contact your local authorities for information on how
to dispose of the product at the end of product life.
86068_Hohlwand-Schraubduebel_Set_A_Content_LB4.indd 3 20.12.12 09:58