Powerfix MS 1000 W - Manual (Page 15)

Portable spotlight 1000 W
GB - Instruction manual Version: Portable spotlight-GB-10-2011_rev.1
6
WARNING: Only use the portable
spotlight with safety glass. Halogen lamps
can cause injuries if they burst.
Replace defective safety glass
immediately.
Plug the earthed plug on the mains cable
into a mains socket. This turns on the
portable spotlight. Disconnect the earthed
plug from the mains socket to turn it off
again.
8. Fault list
Problem/
fault Possible
cause(s) Remedy
The
portable
spotlight
does not
light up The mains
socket has
no voltage. Check the
mains socket.
The
portable
spotlight
does not
light up The halogen
lamp is
defective. Replace the
halogen lamp.
Fig. 3: Fault list
IMPORTANT:
All other repairs must be carried out by a
qualified technician or by the service
department.
9. Cleaning and maintenance
INFORMATION: The following
warnings apply for ALL cleaning,
maintenance and servicing activities.
WARNING: Risk to life and limb
from electric shock
Disconnect the earthed plug from the
mains socket before all cleaning or
servicing work.
WARNING: Risk of burning
Allow the portable spotlight to cool off for
at least 20 minutes after switching off.
Only then may it be touched.
WARNING: Cuts
Protect yourself against the halogen lamp
bursting. Always use a cloth to hold the
halogen lamp. Never touch it with bare
hands.
9.1. Cleaning
WARNING: Risk to life and limb
from electric shock
Disconnect the earthed plug from the
mains socket before all cleaning or
servicing work.
WARNING: Risk of burning
Allow the portable spotlight to cool off for
at least 20 minutes after switching off.
Only then may it be touched.
For electrical safety reasons, use a damp
cloth to clean the outside of the portable
spotlight.
Do not use caustic cleaning agents or
chemicals.
9.2. Replacing the safety glass
WARNING: Risk to life and limb
from electric shock
Disconnect the earthed plug from the
mains socket before all cleaning or
servicing work.
WARNING: Risk of burning
Allow the portable spotlight to cool off for
at least 20 minutes after switching off.
Only then may it be touched.
# 15