Powerfix Z29663 User Manual

Ac b

GB/IE

Product information:
Protractor Spirit Level
Model No.: Z29663
Version:

07 / 2011

Last Information Update: 07 / 2011
Ident. no.: Z29663072011-6

IAN 63679
Milomex Ltd.
c/o Milomex Services
Hilltop Cottage
Barton Road
Pulloxhill
Bedfordshire
MK45 5HP
UK

This device is not a toy. It does not belong in the hands of
children. Children do not appreciate the dangers associated
with the device.

Risk of injury!

Handle the device with care when the scribers have been
inserted into the measuring jaws. Otherwise you could
injure yourself and other people.

Do not damage the spirit levels. If the spirit level is damaged,
avoid coming into any contact with the fluid that is in the
spirit level. Should you come into contact with it, you must
observe the following instructions. First-aid measures with:

SKIN CONTACT: Immediately clean the affected area
with lots of soap and water for at least 15 minutes. If the
skin continues to be irritated, go to a doctor.

EYE CONTACT: Immediately rinse the affected eye with
lots of water for at least 15 minutes. Use your thumb and
forefinger to hold the affected eye open. Go to a doctor
immediately.

INHALATION: Immediately get a lot of fresh air. If there
are respiratory problems, use pure oxygen.

CONTACT WITH THE ORAL CAVITY (MOUTH):
Immediately rinse the inside of the mouth out with lots of
water if the person affected is conscious. Go to a doctor
immediately.

Examples of use

Note: Loosen the locking screw

before opening measuring

jaws

and

. Tighten the locking screw

again after

aligning the measuring jaws.

Measuring angles

Place the measuring jaw

onto the respective area.

Open the measuring jaw

upwards until the bubble of air

in the vertical spirit level

or the horizontal spirit level

is precisely in the centre (see fig. A).
Note: The bubble in the spirit level must be located precisely
in the middle of the marks. The arrowhead indicates the
respective angle on the goniometer scale

Place legs

and

on the surfaces in question. Now

you should be able to read the angle (0 – 270°) between
the two surfaces (see Fig. B).

Measuring areas

Horizontal and vertical surfaces of 0 – 19 ⅝ inch in length
can be measured using legs

and

(see Fig. C).

Using the marking aids for hanging

First place the device against the object to be hung.

Measure and note down the distance between the hanging
fixings on the object.

Place the device on to the desired supporting surface.

Note: Ensure that the marking aids for hanging

point

upwards.

Set the marking aids for hanging

to the previously noted

distance apart.

Now mark the desired positions on the supporting surface
using a pencil or similar marker.

Removing the marking aids

To use the horizontal spirit level

the marking aids

need to be removed.

Mounting the scribers

Open the end caps

Remove the scribers

from the compartment

Insert one scriber

into each opening on the measuring

jaw

The goniometer can now be used as a compass.

Cleaning

Do not use corrosive cleaning agents.

Clean the product with a little mild detergent solution and
thoroughly dry it.

Disposal

The packaging is made entirely of recyclable materials,

which you may dispose of at local recycling facilities.

Contact your local refuse disposal authority for more details of
how to dispose of your worn-out product.

Measuring jaw T

Goniometer scale

Locking screw

Marking aids for hanging

Scope of delivery

1 Protractor Spirit Level
1 Pencil
2 Scribers
1 Directions for use

Technical data

Angle measurement range: 0 – 270°
Bubbles:

1 horizontal and 1 vertical

Legs:

19 ⅝ inch each

Dimensions (closed):

approx. 61.5 x 8.5 x 4.4 cm
(L x W x D)

Safety instructions

KEEP ALL THE SAFETY ADVICE AND INSTRUCTIONS IN
A SAFE PLACE FOR FUTURE REFERENCE!

DANGER OF LOSS OF

LIFE OR ACCIDENT TO INFANTS AND
CHILDREN! Never leave children unsupervised

with the packaging materials. Packaging materials present
a suffocation hazard. Children often underestimate danger.
Always keep the product out of reach of children.

Protractor Spirit Level

Introduction

The instructions for use are a component of this product.

They contain important information pertaining to safety,
use and disposal. Prior to use, familiarise yourself with

all the operating and safety instructions for this product. Only
use the product as described and for the indicated range of
applications. If passing this product on to a third party also
include all documents.

Intended use

This device is suitable for the horizontal and vertical alignment
of an object and for the measurement of angles. Other types of
use or product modifications are not regarded as intended and
may lead to risks such as injuries and damages. The manufacturer
is not liable for any damages caused by any use other than its
intended purpose. The product is not intended for commercial use.

Description of parts

Measuring jaw B

Pencil

Pencil compartment

End cap

Compartment for scriber

Scriber

Vertical spirit level

Horizontal spirit level

Z29663

PROTRACTOR SPIRIT LEVEL

Operation and Safety Notes

GB/IE

270°

0°

63679_pow_Winkelmesser_mit_Wasserwaage_Content_LB6.indd 1

08.07.11 13:30