Powerfix Z16531 - Manual (Page 17)

17 GB/MT
Safetyadvice
Keep all the safety advice and instruc-
tions in a safe place for future refer-
ence!
J WArnInG! DAnGerOF
LOSSOFLIFeAnDACCIDent
tOInFAntSAnDCHILDren!
Never leave children unsupervised with the pack-
aging materials. Danger of suffocation. Keep
out of the reach of children. It is not a toy.
J Always keep the product out of reach of children.
Children often underestimate danger. Store the
device indoors in an enclosed, dry place where
it cannot be reached by children.
J Ensure that staples and nails cannot under any
circumstances strike people or animals. Failure
to observe this advice may lead to injury.
J Wear personal protective equipment and always
wear safety glasses. This also applies to people
who may be helping with the work by support-
ing or holding the workpiece.
m CAUtIOn! Do not support yourself with your
hands under any circumstances near or in front
the stapler gun or on the surface being tacked.
One slip may result in injury.
J Every time before you use the device, check
that it is in perfect condition. Damage to any of
its components may lead to injury.
J Check that all parts have been assembled and
fitted properly. Incorrect assembly or fitting
may lead to injury.
J Remain alert at all times and always watch what
you are doing. Proceed with caution. Just one
moment of inattention during assembly may
lead to injury.
J Before moving or putting away the stapler gun,
check that there are no staples or nails still in
the device.
Q
Operation
Q
Fillingwithstaples/nails
m CAUtIOn! Use only the staples and nails
described in these operating instructions (see
“Staples / nails”). Failure to observe this advice
may result in damage to the device.
note: You can use three different types of staples /
nails in the stapler gun; flat crown staples, round
crown staples and T-nails. All three types are sup-
plied with the stapler gun.
Followthesesteps:
1. Press in the staple pusher
2 slightly and then
pull it downwards. Then pull the staple pusher 2
completely out of the magazine 4 (see Fig. A).
2. Push the staples or the T-nails into the maga-
zine 4 .
m CAUtIOn! Ensure that the staples or T-nails
are correctly inserted (see Figs. B, C, D).
3. Push the staple pusher 2 back into the maga-
zine 4 . Press in the staple pusher 2 slightly
and then pull it slightly upwards to fix it in place.
Q
Settingtheimpactforce
m CAUtIOn!Never screw the adjusing screw 7
completely out of the stapler gun. This could result
in damage to the device.
j Screw out the adjusing screw 7 to reduce
the impact force.
j Screw in the adjusing screw 7 to increase
the impact force.
Q
Stapling
m CAUtIOn! Never support yourself by placing
your hands near or in front of the stapler gun or the
workpiece surface. A slip can result in injury.
Followthesesteps:
1. Press the staple eject opening
6 on the spot
where you wish to staple.
Safety advice / Operation
49831_Handtacker_Content_LB5new.indd 17 18.01.10 10:37