Edimax Technology i-Watcher Pan/Tilt Internet IP Camera - Manual (Page 21)

8-3-2. Motion detected mail function (Mail Setting)
When motion detection is enabled, the user can setup the mail function to send the
motion-detected images to the preset mail address. The procedures are as follow:
X Motion Detect set to “Enable” state.
Y Setup the “SMTP Mail Server” and E-Mail
address. (Password use or not)
Z Enter the sender’s email address in “Sender”
field and the recipient’s email address in the
“Receiver” field.
[ The user can change the “Subject” field.
\ If the mail server needs authentication, check the
“Password” check box. Also, enter the password;
otherwise the “Password” field does not need to
be filled in.
] Check the “Send mail when motion detected” check box to enable the operation. If the
check box is not checked, the motion detected send mail function will not be enabled.
^ Confirm by selecting [Save Settings] option to save the settings.
Note:
If all of the items are enabled resulting in a motion event detection, the i-WATCHER
will send the motion-detected images to the preset email address. The maximum
number of images allowed is 6 images per mail.
8-3-3. Motion detected mail
The received mail will be displayed in a motion
Picture form. It can also be displayed as
separated images with a selection of the circle
button on the left side of
the Image Viewer.
8-3-4. Motion detected message on the main window.
When the motion detection function is enabled, and a motion detected, a message will be
displayed at the bottom.
Motion detection disabled or Motion detection enabled
21