Edimax Technology i-Watcher Pan/Tilt Internet IP Camera - Manual (Page 15)

A. Setup the mapping of HTTP Port (80) to 192.168.0.49.
B. Restart the ADSL router.
Then the i-WATCHER can be accessed from WAN, by the ADSL WAN IP Address.
3-5. Access the i-WATCHER by ordinary user login.
If the user accesses the i-WATCHER by an ordinary user account, the i-WATCHER would
not allow the user to access the privileged functions. From the following screen, the
Camera Control, Resolution, Quality, and Configuration are disabled.
4. i-WATCHER Network Camera on-line
After setting up the IP based on the above step, connect to the intended network or LAN.
Execute IE directly on PC. The left side of the above diagram is the control panel and the
right side is image display.
5. Change Password
Before you select “Change Password” check button, make sure “User authorization
required” enable the user check function
1. When you want to Change Password, set a new
password to replace the old password.
2. If you get this message from windows screen, that
mean “User authorization required” mode is not set yet.
Please Click “Configuration
Æ User Setup Æ User
Management
Æ User authorization required
15