Emerson I/O MODULE IPMC7126E - Manual (Page 32)

IPMC7126E/7616E I/O Module Installation and Use (6806800A45B)
Chapter 3 Programming
18
The IDSEL assignments for both modules are shown below:
The following table shows the Vendor ID, the Device ID, and Revision ID for each of the planar
PCI devices on the IPMC712 and IPMC761:
PCI Arbitration Assignments on Host Boards
The IPMC module PCI arbitration is provided by the host board.
MVME5100
The MVME5100 PCI arbitration is performed by the Hawk ASIC on the host board which
supports eight external PCI masters. Included is the Hawk itself and seven external PCI
masters. The arbitration assignments for the IPMC712 and IPMC761, when installed on the
MVME5100, are as follows:
MVME5500
The MVME5500 IPMC module PCI arbitration is performed using logic implemented in
Programmable Logic Devices (PLDs). These arbiters use a rotating priority scheme for fairness
and bus parking and will always be on the GT-64260B. There are no software programmable
modes to these arbiters.
Table 3-3. IDSEL and IDSELB Mapping for PCI Devices
Device Number
Field
PCI Address Line IDSEL Connection
0b0_1011 AD11 PCI/ISA Bridge
0b1_0000 AD16 PMC Slot 1 SCSI Device
0b1_0001 AD17 PMC Slot 1 MVME5500
0b1_0101 AD21 PMC Slot 1 MVME6100
Table 3-4. On-Board PCI Device Identification
Device Device Vendor ID Device ID Revision ID
SCSI Controller LSI SYM53C895A 0x1000h 0x0012h 0x00h
PCI-ISA Bridge W83C554F 0x10ADh 0x0565h XXh
Table 3-5. PCI Arbitration Assignments
PCI Bus Request PCI Master(s)
Request 1 (PARBI1) PMC Slot 1 (SCSI device on the module in PMC Slot 1)
Request 2 (PARBI2) PIB device on the module in PMC Slot 1